How To Reset The Airbag Light?

1. Turn ignition switch off, remove ECU service connector
2. Connect (jump) the MES connector (this is 2 pin yellow connector wrapped in yellow plugged in the front of the underdash fuse box)
3. Turn ignition switch on
4. SRS light will come on for 6 secs then go out, remove the jumper within 4 secs after the light goes out.
5. The SRS light will come on again, reconnect the jumper within 4 secs after the light has come on.
6. The SRS light will go off, remove the jumper with in 4 secs after the light has gone off.
7. The SRS light will blink two times indicating the memory is reset.
Link to finding MES connector . It’s not a Fit but will give you a general idea.

Or try trhis:
Ignition Key Method:
1) Turn IGNITION on (but don’t start car)
2) After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.
3) Wait 4 seconds
4) Turn IGNITION on (but don’t start car)
5) After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.
6) Wait 4 seconds
7) Turn IGNITION on (but don’t start car)
8) After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.
9) Wait 4 seconds
10) Turn IGNITION on (but don’t start car)
11) Wait 3 seconds
12) Turn IGNITION off
13) Wait 2 seconds
14) ST ART Car (the light may be blinking slower than before)
15) Wait 3 seconds
16) Turn IGNITION off
17) Wait 3 seconds
18) ST ART Car

Click to find related airbag reset tool.

Similar posts