Skip to main content

How Do You Use the KWP2000 PLUS?

How do you use the KWP2000 PLUS? 1.You need a computer. Installing KWP2000 Plus software. 2.Connect USB cable to your PC; 3.Connect to your car via standard 16-pin OBD2 connector; 4.Supports high speed ECU flashing 5.Led indications for USB-power Car-power/rx/tx 6.Support KWP2000+ software and other KWP/ ISO software How to Read and Write data with […]

How To Install Xprog-box 5.45?

1.Shut off the computer anti-software . if not , will kill the software 2.Close the internet. If not ,will damaged the hardware ,and cannot be repaired without any warranty. 3.Uninstall all the xprog-m, or xprog box software -higher or lower software, make sure that your pc only install our software for our xprog-box 5.45, our […]

How to update DATA SMART3 software?

The steps are similar among “active function”, “software update” and “firmware update”. Take “software update” for example. First please ensure you’ve installed USB driver well, connect the device to PC through USB and plug the test connector to the device. Then power on. Choose the option”PC_LINK”, shown as figures below Run PC_LINK software on your […]

Add KTAG ECU Programmer Tokens For Free

Ktag:http://www.obddeal.com/ktag-ecu-programming-tool-master-version-p-3004.html Open KTAG J-Link B8 ADD tokens file. Check out how to solder KTAG’s PCB. Solder the PCB; make sure circuit board of PCB is well welded like that in the picture. Connect the PCB to a laptop’s USB port to charge. If the PCB board is not charging, its software will not work properly. […]

FORD VCM IDS License Installing Notice

FORD VCM IDS License Installing Notice: 1. Please don’t run the FORD VCM IDS software, before you install the License “Ford-License for IDS.exe”. 2. If you can see the windows process “XMLRegistryD.exe” in the windows task manager, then kill the windows process “XMLRegistryD.exe” before you run the “Ford-License for IDS.exe” License. While you install the […]